Sniper

Snipe tokens the moment a pool is created for a specific address. (Only on EVM)

When you enter a token address, if no pool is found but a token exists at that address, you can set up a sniper. The sniper will automatically buy the token as soon as a pool is created, using the amount you specified. You can manage your targets under /sniper

The sniper starts monitoring after you enter a token that doesn't have a pool yet

After that, just define the amount to snipe with.\

The amount has been set

Then, you can configure a few settings:

• ❌ Remove Sniper Target – Stops sniping this token.

• 💧 Min Liquidity – Set the minimum liquidity required before sniping.

• 🚀 Boost – Executes the transaction with fewer checks for faster speed. ⚠️ Use with caution: this may cause unexpected behavior.

• 📉 Slippage – Set the maximum slippage allowed for the transaction.